Adhesives - Rail

Features

  • Fast room temperature cure
  • Excellent environmental resistance
  • Superior fatigue resistance
  • Primer-less adhesion
  • High strength and high elongation
  • Thixotropic

Benefits

  • Enable lower mass materials
  • Reduce cost of assembly
  • Improve durability via stress distribution and higher fatigue resistance
  • Enable the use of mixed materials
  • Reduce leak potential

Assembly Optimization
Replacing Rivets in the Assembly Process

Substrate Bonding
Metal to Metal Bonding


MA420 (AO420)
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. AO420 is a rapid-curing system and is the standard choice for composite bonding applications in the transportation industry.
MA8110
Two-part methacrylate adhesive designed for structural bonding of galvanized metal assemblies. Combined at a 1:1 ratio, MA8110 is a fast-curing system. Plexus MA8110 is designed primarily for bonding galvanized coated metals, in particular Hot Dipped G90 and G60.
MA8120
An advanced direct-to-metal, low halogen two-part methacrylate structural adhesive. It is designed for the structural bonding of various metal, plastic, and composite assemblies.
MA300
Two-part methacrylate adhesive designed for structural bonding of composite, thermoplastic, and metal assemblies. MA300 has a working time of 3 to 6 minutes and reaches approximately 500 psi in 12 minutes and 1000 psi in 15 minutes at 74°F (23°C).
Plexus MA310
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. Plexus MA310 is a medium-curing adhesive system. Plexus MA310 offers a combination of high strength and stiffness as well as the ability to bond a wide range of materials.
MA832
Advanced two-part methacrylate adhesive designed for structural bonding of metals without primers. In addition, MA832 does a superb job of bonding thermoplastic and composite assemblies with little to no surface preparation.
MA530
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. This product has been designed for use on large structures where a moderate open time product is needed. MA530 may be used for composite and metal bonding for small to large structures.
MA560-1
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. Designed for use on large structures where a very long open time product is needed. Plexus MA560-1 is commonly used for bonding stringers and liners into large fiberglass boats with bond lines up to 1.00 in. (25 mm) thick.