Plexus Adhesives - Bus

Features

  • Fast room temperature cure
  • Excellent environmental resistance
  • Superior fatigue resistance
  • Primer-less adhesion
  • High strength and high elongation
  • Thixotropic

Benefits

  • Higher vehicle fuel or EV range due to lower mass
  • Reduced cost of assembly 
  • Improved durability

Applications 
Reinforcement Bonding

Substrates
Metal to Metal Bonding


MA8110
Two-part methacrylate adhesive designed for structural bonding of galvanized metal assemblies. Combined at a 1:1 ratio, MA8110 is a fast-curing system. Plexus MA8110 is designed primarily for bonding galvanized coated metals, in particular Hot Dipped G90 and G60.
MA8120
An advanced direct-to-metal, low halogen two-part methacrylate structural adhesive. It is designed for the structural bonding of various metal, plastic, and composite assemblies.
MA1020
Two-part methacrylate adhesive with very low cure shrinkage and very low odor.
MA1025
Two-part methacrylate adhesive with very low cure shrinkage and very low odor designed for structural bonding because it requires virtually no surface prep.
MA830
Two-part methacrylate adhesive designed for structural bonding of metals without primers. In addition, MA830 does a superb job of bonding thermoplastic and composite assemblies with little or no surface preparation.
MA832
Advanced two-part methacrylate adhesive designed for structural bonding of metals without primers. In addition, MA832 does a superb job of bonding thermoplastic and composite assemblies with little to no surface preparation.
MA420 (AO420)
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. AO420 is a rapid-curing system and is the standard choice for composite bonding applications in the transportation industry.
MA320
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. MA320 is an excellent choice for composite bonding applications in the transportation, marine, wind energy, and engineering construction industries because of its high strength and durability.
MA530
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. This product has been designed for use on large structures where a moderate open time product is needed. MA530 may be used for composite and metal bonding for small to large structures.
MA560-1
Two-part methacrylate adhesive designed for structural bonding of thermoplastic, metal, and composite assemblies. Designed for use on large structures where a very long open time product is needed. Plexus MA560-1 is commonly used for bonding stringers and liners into large fiberglass boats with bond lines up to 1.00 in. (25 mm) thick.